Nortel Networks CTA 500dm User Manual
56 AT commands
CTA 500
dm On Line Guide
P0873832 Issue 05
Set Stop Bits
The Set Stop Bits Command
&P6=value
sets the number of stop bits on the interface between the CTA 500dm
and the attached computer. The following table shows the supported
values.
and the attached computer. The following table shows the supported
values.
Result Codes
OK Appears when the value is supported.
ERROR Appears when the selected value is not recognized or is not
supported.
supported.
Serial Interface Control Lines
Change the operation of the control lines on the serial interface by
using AT commands.
using AT commands.
Value
Use
0
one stop bit (default)
1
one and one-half stop bits
2
two stop bits