Nortel Networks Medical Alarms P0919417 03 User Manual

CallPilot Reference Guide

With Call Record 

≤·°· you can record an active telephone call and put the resulting 

message in your mailbox. Before you activate Call Record, ask the parties on the call for 
permission to record the call.

The maximum length of the Call Record message is determined by the Class of Service setting for 
your incoming message length. If the mailbox message length is reached, you hear the voice 
prompt “Recording stopped. The recording limit has been reached” and the recording ends. After 
Call Record stops, you can re-activate 

≤·°· to start another record call session. The call 

is recorded in two separate messages if you do this. Ask your System Administrator for the 
message length that is assigned to your mailbox.

If you use record a call, CallPilot puts the recorded call in your mailbox. You can forward the 
recorded call to other mailboxes.

Call Record is not enabled by default. The System Administrator must enable this 

feature by assigning you a Class of Service that includes Call Record. In some areas Call 
Record is not available as it contravenes local laws. Ask your System Administrator 
about the availability of Call Record in your area.

While you are on an active call, press 

≤·°·.

Before recording begins, all parties on the call hear the prompt 
“This call is being recorded” and a recording tone.

Press QUIT to end recording
or
press PAUSE to suspend recording.
Press RESUME to continue recording or press QUIT to end recording.

When you stop recording, all the parties on the call hear the prompt 
“Recording stopped.”

Press 

® to end the call.

Recording
PAUSE                     QUIT