Nortel Networks Circuit Card User Manual
NT7D16 Data Access card
Page 517 of 906
Configuring the Data Access card
LD 11 must be configured to accept the DAC. The commands listed here
must be answered. LD 20 prints out card information when requested. For a
complete list of the service change prompts and responses, see Software
Input/Output: Administration (553-3001-311).
must be answered. LD 20 prints out card information when requested. For a
complete list of the service change prompts and responses, see Software
Input/Output: Administration (553-3001-311).
DAC administration (LD 11)
Responding R232 or R422 to the TYPE prompt in LD11 begins the prompt
sequence for the DAC configuration. Responses to the following prompts are
sequence for the DAC configuration. Responses to the following prompts are
22R
22
O-V
GND5
7
SDB5
Connector
23T
48
V-G
DCD5
8
3
23R
23
G-V
DSR5
6
24T
49
V-BR
RI5
22
24R
24
BR-V
CTS5
5
Table 171
RS-232-C and RS-422 pinouts for last three DAC ports (Part 2 of 2)
RS-232-C and RS-422 pinouts for last three DAC ports (Part 2 of 2)
I/O cable
Unit no.
RS-232-C
RS-422
Signal
Patch pair or
octopus
Pair
Pin
Pair
color
Signal
Pin no.
Note: Units 4 and 5 are available when the DAC is installed in a fully wired 24-pair slot.