Nortel Networks Circuit Card User Manual

 Acceptance tests

When you see the DN? prompt, enter the directory number (DN) you want 
the system to dial.

If the system response is other than OK, see the Software Input/Output: 
Administration (553-3001-311) to analyze the messages.

End the session in LD 36:
****

Test an automatically identified outward dialing (AIOD) trunk card:
LD 41
AIOD l s c

loop, shelf, and card numbers

If the system response is other than OK, see the Software Input/Output: 
Administration (553-3001-311) to analyze the messages.

End the session in LD 41:
****

Use this procedure to test a tone and digit switch (TDS) card or to test the TDS 
function of an NT8D17 Conference/TDS card.

Log into the system:
LOGI (password)

Obtain a list of terminal numbers (TNs) for disabled TDS cards:
LD 34
STAD

If the TDS loop to be tested is disabled, enable it.

For an NT8D17 Conference/TDS card, enter:
ENLX loop 
(the TDS/MFS loop is the even loop of the conference/TDS loop pair)

Note: The conference/TDS card is not enabled automatically when it is 
inserted. You must enable the card with the command ENLX. (This 
command is used in LD 34 and LD 46 to address even loops and in LD 38 
to address odd loops.) Enabling the loops with the command ENLL does 
not enable the hardware for the card.