Network Technologies CAT5 User Manual

H A - P S 2

( R e a r V i e w )

C A T 5 C a b l e

t o U s e r S t a t i o n

C a b l e t o C P U

T e r m i n a t i n g

P l u g ( S u p p l i e d )

Connecting the CAT5 cable to the Host Adapter

Connect CAT5 cable to the “OUT” port on the Host Adapter. (See Fig. 5.) When properly inserted the cable end should snap into
place. Also be sure to insert the Terminating Plug into the "IN" port on the Host Adapter if this is the only Host Adapter in the
segment. Otherwise, see "Daisy-Chained Host Adapters" on page 9 to add more Host Adapters to the segment.

NOTE: If an RJ45 wall outlet is being used, connect the other end of the extension cable

to the RJ45 wall outlet.

WARNING: Never connect the PRIMUX Host Adapter to an Ethernet card,

Ethernet router, hub or switch or other Ethernet RJ45 connector of an Ethernet
device. Damage to devices connected to the Ethernet may result.

NOTE: The installer must ensure that all CAT5 cable between the Host Adapter
and User Station is of the straight-through type and not crossed.

Figure 5- Connect CAT5 cable to Host Adapter

The User Station

The PRIMUX-UZR User Station can be used with either PS/2 devices or USB devices.

NOTE: If the user keyboard connected is PS/2 (6mD connector), then the mouse must also be PS/2. If the user
keyboard is USB (USB Type A connector), then the mouse must also be USB.

Installation with PS/2 devices

1. Position the User Station such that the CAT5 cable, the monitor cable, device cables, and the AC adapter power connector

can each reach the User Station without cable strain.

2. Connect the monitor cable to the female 15HD video connector on the User Station.

3. Connect the PS/2 device(s) to the User Station (see Fig. 6).

a. Connect the keyboard to the purple female 6 pin miniDIN connector on the User Station.

b. Connect the mouse to the green female 6 pin miniDIN connector on the User Station.