Netcomm NB1300PLUS4 User Manual
Rev. 1 - YML674
www.netcomm.com.au
NB1300Plus4 ADSL Modem
Page 11
Overview
Factory Defaults
The following table lists the Factory Defaults of your NB1300Plus4 ADSL Modem:
Field
Setting Details
LAN IP address:
192.168.1.1
LAN Subnet Mask:
255.255.255.0
DHCP Server:
Enabled
User Name:
admin
Password:
password
Main Function:
Router (Bridge Disabled)
WAN connection type:
PPPoE LLC
VPI:
8
VCI:
35
Note:
These defaults may change with firmware updates and factory changes, please
consult the NetComm website to check for the latest defaults.
consult the NetComm website to check for the latest defaults.
Resetting to factory defaults
If you forget your passwords, lock out HTTP or FTP access or simply can’t remember what IP
address you have set the NB1300Plus4 on you will probably need to perform a factory defaults
reset.
address you have set the NB1300Plus4 on you will probably need to perform a factory defaults
reset.
To perform a factory defaults reset you must have physical access to the unit then follow these
steps;
steps;
1. Make sure the NB1300Plus4 is powered on and the RDY light is flashing.
2. Locate the Reset button hole on the back of the unit.
3. Gently press in and hold the button for 5 seconds with a suitably thin appliance (E.g.
straightened paper clip) seconds after release the RDY light will turn off.
4. Watch the RDY light and wait for it to stabilise and start pulsing again (in approximately 1
minute.
Note:
Do not switch off or press reset again until the NB1300Plus4 has completed its
reset and the RDY light is flashing.
5. Your router should now be set to factory defaults (192.168.1.1, ‘admin’ & ‘password’)