Navman FISH 4500/4600 User Manual
Symbol Alarm Beeper Alarm condition is
Name
Name
Cycle
met
when
the:
Too
1
/
5
sec depth is less than
shallow
the alarm trigger
value
Too
Too
1
/
2
sec depth is greater than
deep
the alarm triggervalue
Fish
1 short echo matches the
beep
profile of a fish
Temp.
1
/
2
sec temperature equals
the alarm triggervalue
Temp.
1
/
2
sec rate of change of
rate
temperature
equals
the
alarm trigger value
Low
1
/
2
sec battery voltage is
battery
less than the alarm
trigger
value
Low
1
/
2
sec fuel remaining equals
fuel
the alarm trigger value
3-5 Setup > Alarms
Press MENU one or more times until the Setup
menu is displayed, then select Alarms:
menu is displayed, then select Alarms:
Trigger settings can be defined to suit the boat
and individual preferences as follows:
and individual preferences as follows:
Alarms can be set (enabled) to automatically detect
certain conditions, such as the water being too shal-
low. Alarms that are enabled are shown as black
icons in the Alarm status box on the sonar displays.
certain conditions, such as the water being too shal-
low. Alarms that are enabled are shown as black
icons in the Alarm status box on the sonar displays.
When an enabled alarm is triggered, the beeper
sounds, an alarm message is displayed and the
alarm status icon is shown in red.
sounds, an alarm message is displayed and the
alarm status icon is shown in red.
Press ENT or ESC to acknowledge the alarm,
stop the beeper and close the alarm window. This
does not disable the alarm.
stop the beeper and close the alarm window. This
does not disable the alarm.
Alarms automatically re-enable
The Too shallow, Too Deep and Low bat-
tery
tery
alarms automatically re-enable when the
value moves outside the alarm trigger setting.
The Temperature alarm automatically re-
enables when the temperature is more than
enables when the temperature is more than
0.45°F (0.25°C) above or below the alarm trig-
ger setting.
ger setting.
The Temperature rate alarm automatically
re-enables when the rate of temperature change
falls below the trigger setting by more than 0.2°F
(0.1°C) per minute.
re-enables when the rate of temperature change
falls below the trigger setting by more than 0.2°F
(0.1°C) per minute.
Flashing light and/or external
beeper
beeper
If a secondary alarm indicator is required, a flashing
light and/or external beeper can be installed. These
can be positioned anywhere suitable on the boat.
See section 6-5 Wiring options.
light and/or external beeper can be installed. These
can be positioned anywhere suitable on the boat.
See section 6-5 Wiring options.
3-6 Setup > Units
Press MENU one or more times until the Setup
menu is displayed, then select Units:
menu is displayed, then select Units:
The default units are
shown in this example.
Distance
Select from:
•
nm (nautical miles)
•
mi (miles)
•
km (kilometres)
Speed
Select from:
•
kn (knots)
•
mph (miles per hour)
•
kph (kilometres per hour)
Depth
Select from:
•
ft (feet)
•
m (metres)
•
fa (fathoms)
Fuel
Select from:
•
Litres
•
USGal (US gallons)
•
ImpGal (Imperial Gallons)
Temperature
Select either:
•
°F (Fahrenheit)
•
°C (Celsius)
Wind
• True
• Apparent
• True
• Apparent
Pressure
• kPa
• psi
• kPa
• psi
FISH 4500/4600 Installation and Operation Manual
12
NAVMAN