Kreisen 3 8 6 X / X E User Manual

The computer responds with:

Write data into CMOS and exit (Y/N)?

Press Y. The 

computer 

will update the information in its

configuration RAM, and will go through the start-up routine
again. Make sure MS-DOS is installed on floppy disk or hard

disk of your system, so the system will boot up in MS-DOS.

Note
Your system has an on board IDE type HDC 

and if you

want to install the another type of HDD except IDE, you

must disable the on board IDE HDC using the Extended
Setup Program. See Chapter 2 for the detailed information
of it.

After the DOS Shell screen appears, select the Command

Prompt option. 

At this point your are ready to partition your

hard disk drive.

To do this, enter the command:

A > FDISK

After loading the FDISK program, the computer will display

information on the hard disk drive installed in the system, as

follows: