Kramer Electronics Computer Monitor PL-150 User Manual
Flash Memory Upgrade
29
8 Flash Memory Upgrade
The PL-50 uses a microcontroller that runs firmware located in FLASH
memory. The latest version of firmware can be downloaded from the Kramer
Web site at
and updated in minutes using the
K-UPLOAD and the following procedures.
Before firmware upgrade:
Close the embedded Web pages
Do not press the front panel buttons
8.1 Upgrading the Firmware
2. Connect a PC to the PL-50 (see section
3. Update the firmware using the K-UPLOAD (see section
8.1.1 Download the Firmware
To download the latest firmware file
1. Go to the Kramer Web site at
from the Internet:
2. Navigate to SUPPORT / Software Firmware Updates.
3. Click on the link of the firmware that applies to your product. Download it
3. Click on the link of the firmware that applies to your product. Download it
and save it to disk.
4. Extract the file to a folder (for example, C:\Program Files\Kramer Flash).
8.1.2 Connect a PC to the PL-50
To connect a PC to the PL-50, make any one of the following connections:
•
Connect a serial cable from an RS-232 9-pin D-sub rear panel port on the
PC to the PL-50.
•
Connect a USB cable from a USB port on the PC to the USB port on the
PL-50
•
Connect an RJ-45 Ethernet cable from the Ethernet port on the PC to the
1 The files indicated in this section are given as an example only. File names are liable to change from time to time