Klark Teknik U.S.A. Stereo Equalizer DN9340E User Manual

Operation: DN9340E 

 

 

22 

 

Select filters by pressing the FILTERS button. 

 

 

 

The display for the filters is similar to the home page, showing the frequency response - in this case 
just for the filters.  At the top is a legend that indicates which filter is currently active for control and 

also how many filters are in use.  So, for example, if we have three filters in use, and are adjusting 

the second one the legend would read “Filter 2 of 3”.  If no filters are active, then the display is blank 

except for the ADD key.  Press this key to add a filter. 

 

Turn the left encoder to select the type of filter required.  The available options are Notch, Low-pass 
(normal and peaking), High-pass (normal and peaking), Hi shelf and Lo shelf.  Turn the right encoder 

to confirm the selection and create the filter.  There are four filters available to each channel, each of 

which can be used across the whole frequency range from 20Hz to 20kHz. 

selects which filter is to be controlled. 

steps through the following pages on the alphanumeric display.  After the 

last page, the next press returns to the first page, and so on. 

adds a new filter. 

pressing this allows an individual section to be switched in and out of 

circuit. 

 

 

 

The controls available vary depending on the type of filter selected: 

Notch Frequency 

Q 

- 

Low Pass (LPF) 

Frequency 

Normal/Peaking 

Slope/Gain 

High Pass (HPF) 

Frequency 

Normal/Peaking 

Slope/Gain 

Hi Shelf 

Frequency 

Slope 

Level 

Lo Shelf 

Frequency 

Slope 

Level 

Number of active filter section 

Soft key display