Kenwood Sovereign VR-5080 User Manual
45
Using R
eceiv
er
How Do I Operate Devices?
To tune into a radio station:
1. Select the Tuner input (see page 35).
2. Select the FM or AM band.
MULTI
CONTROL
fi
%
P.CALL
MEMORY
AUTO
BAND
fi
%
+
-
+
-
/
8
/
7
1
1
•
Press the BAND button on the receiver
•
Or press the ENTER (BAND) button on Remote Control unit.
3. Press Remote Control unit’s TUNING (
2/1, 3/¡) button or the
receiver’s MULTI CONTROL (
%/fi) button to start Auto tuning until
the desired station is tuned in.
If the radio wave from the station is weak and hard to tune in, press
the AUTO/MONO buttons on Remote Control unit or AUTO button
on the receiver to select Manual tuning. In this mode, each press of
the TUNING button varies the tuning frequency by one step.
the AUTO/MONO buttons on Remote Control unit or AUTO button
on the receiver to select Manual tuning. In this mode, each press of
the TUNING button varies the tuning frequency by one step.
Presetting radio stations
The following operation should be performed on the receiver.
The following operation should be performed on the receiver.
1. Tune into a desired station.
2. Press the MEMORY button.
3. Press Remote Control unit’s TUNING (
2/1, 3/¡) button or press
the receiver’s P.CALL (
%/fi) button to display the desired preset
memory bank number.
4. Press the MEMORY button to preset the station under that number.
5. To preset other stations, repeat steps 2 to 5 for each.