Kärcher 600 MP User Manual

4

Version 06/05

Before starting operation:

• Make sure that the equipment is connected to 

the untreated water source and the respective 
transporting gear, e. g., admission-pressure 
unit.

• Ensure the unrestricted flow of the drinking water 

into a tank or a suitable device on the user side.

The admission-pressure unit consists of a 
pump (21) and a control device (22). The operat-
ing condition of the pump is indicated with three 
indicator lights:

• Green (24):

Ready for operation

• Yellow (25):

Pump delivering

• Red (26):

Malfunction or water low

• The reset button (23) starts the pump after fail-

ure

• Put on protective clothing.

• Open the lid (27) of the metering station (30).

• Fill the respective chemical into the metering 

station according to Section 3.2.6.

• Add the corresponding amount of chlorine-free 

drinking water.

• Shut the lid of the metering station.

• Pull the mixing rod (28) out of the metering 

station to the stop and push back in again.
Repeat this procedure for approx. 5 minutes 
until the chemical is completely mixed.

The equipment may be put into operation only when set-up, installed and prepared for oper-
ation by an authorized KÄRCHER specialist dealer.

The drinking water must be able to run 
off without counterpressure. The height 
difference must not exceed 3 m.

In case an admission-pressure unit 
is necessary, it will be installed by a 
Kärcher service technician.

If the system is equipped with one or 
more metering stations, it must be en-
sured that these are correctly filled and 
connected.

The metering stations must not be 
mixed up or mistaken, meaning filled 
with the wrong chemical.