Mr. Coffee TP50 User Manual

1. Fill the pitcher with fresh, cold water to the

desired water level capacity (1, 2 or 3 quarts). Do
not overfill.

2. Lift the water reservoir lid, rotate the shower head

out of the way and remove the brew basket. Pour
water into the water reservoir.

3. Place the brew basket back in its place, inserting

an 8-12 cup MR. COFFEE® paper filter into the
brew basket. Add the desired amount of tea or
coffee (see the Measurement Chart). You may now
add sugar, lemon or other flavorings to the brew
basket to suit your taste.

4. Rotate the shower head back into position so that

it is now over the brew basket. Close the water
reservoir lid.

5. Adjust the steeping lever to your desired brewing

strength. The farther the lever is to the right, the
stronger the tea.

6. Fill the pitcher with ice cubes to the desired ice

level marked on the pitcher. Replace the pitcher
lid with the lid spout cover in the open position.
If you are low on ice, you may substitute cold
water, refilling the pitcher to the desired 1, 2 or 3
quart WATER level – DO NOT fill to the ICE level as
this will cause an overflow when the tea or coffee
brews.

7. Slide the pitcher towards the iced tea maker with

the pitcher spout open and fitting just under the
Steep Control, flush against the appliance.

NOTE: If the pitcher and its lid are not pushed snugly

against the iced tea maker, hot water and hot
steam could escape and cause injury. 

8. Turn the iced tea maker on by plugging the power

cord into an electrical outlet and pushing the “on”
button firmly until the ON indicator light is
illuminated.

4. Rotate the shower head back to its proper position over the brew basket.

Close the water reservoir lid.

5. Place the pitcher lid on the pitcher. Open the pitcher spout cover. Slide the

pitcher towards the iced tea maker with the pitcher spout fitting just under
the Steep Control.

6. Plug the power cord into an electrical outlet and push the “on” button.

7. When the cycle is complete, your iced tea maker will shut off automatically.

8. Slide the pitcher away from the iced tea maker and discard the water in the

pitcher.

NOTE:  Plugging the iced tea maker into an electrical outlet may trigger the 

brewing cycle since the “on” button may have inadvertently been 
pushed. Also, if you wish to turn the iced tea maker off during the 
brewing cycle, just grasp the molded plug and unplug the power 
cord.

Your iced tea maker is now ready to use. Enjoy it!