Multi-link Multi-Link Acp-300 ACP-300 User Manual

TO READ VALUES FROM MEMORY 
To read all values, press 99 on your telephone key pad. To read the value of a 
single register, press * and the two-digit register number. 
 
TO WRITE PROGRAMS TO MEMORY 
Press 80 on your telephone key pad. This should always be done when you are 
satisfied with the information you have programmed. 
 
TO EXIT PROGRAMMING MODE 
Press 90 on your telephone key pad. 
 
IMPORTANT: The ACP MUST be the first device on the phone to insure 
accurate routing. In a rollover sequence, install the ACP on the last line of 
rollover. 
 
Note: Device port #2 is the default fax port (can be used as a modem port).

 

 

 

 
Model Number ACP‐300; ACP‐500; ACP‐900 
 
Input Power Requirements 
At AC Transformer: 100‐240 Volts AC , 50‐60 Hz 
At Power Jack on ACP: 12‐15 Volts DC (Center pin positive) 
Grounded power supply recommended 
 
Power Consumption: 

(12VDC Input) 4 Watts 

(12VDC Input) ≈ 2.5 Watts 

 
CO Interface 
Ringer Equivalence Number: 1.1B 
Input Ring Detection: 50‐150 VAC, 15‐68 Hz 
 
Physical: 6.3" W x 9.5" D x 1.4" H, 1 lb 
Operating Temperature: ‐20°F to 120°F 

 

Battery: ‐38 Volts DC to all ports 
Off‐Hook Detection: 8‐150 mA 
Ring Generator Frequency: 33 Hz 
 
Waveform: Sinusoidal 
 
Following values are with 12VDC input 
(Values increase with 14/15 VDC input) 
Ringing No Load: Approximately 105 Volts AC 
Ringing 8K Ohm Imp. (REN1.0): Approx 90 Volts AC 
Ringing 4K Ohm Imp. (REN2.0): Approx 78 Volts AC 
Ringing 2.7K Ohm Imp. (REN3.0): Approx 68 Volts AC 
 
Warranty: 2 Year Limited 
FCC Registration# GK7USA‐73200‐KX‐N