Moultrie GAMESPY DIGITAL CAMERA M80 Instruction Manual

Slide the UNLOCK switch on the bottom of Camera and use the knob to pull 

the slide-out Battery Tray. Install four(4) or eight(8) AA size alkaline or 

lithium batteries with polarities as indicated in the Battery Tray. Re-install the 

Battery Tray.
Thread the provided Mounting Strap through the Eyelets on the back of the 

camera and secure to a tree or pole approximately 36" from the ground as 

shown.
Turn Camera on by sliding ON/OFF/AIM switch to 

the ON position.
Press the MODE button one time to get to the 

Camera Setup Menu. Set Time and Date by pressing 

ENTER, using UP/DOWN to adjust selected field, 

LEFT/RIGHT to move to the next field and ENTER 

when done. 
Press MODE button until MENU SELECTION 

screen is displayed.  Use the UP/DOWN buttons 

until the MAIN SCREEN option is highlighted 

yellow.  Press ENTER.
Your Camera will now automatically take pictures 

whenever an animal is detected in range -based on 

the default settings below.

Eyelet

Mounting 

Strap

M80 GameSpy Digital Camera

PlotStalker Software

Capture Mode  

TRAIL CAM (Still)  

Photo Quality  

HIGH  

Photo Delay after each photo is taken  

1 MIN  

Multi Shot Count  

1-SHOT  

Digital Zoom 

NO ZOOM 

Video Resolution 

HIGH 

Video Length 

5 SEC 

Video Audio 

ON 

Camera Name  

MYCAMERA  

Temperature  

Fahrenheit  

Info Strip printed on photos  

ON  

Plot Frequency 

15 SECONDS 

Plot Duration 

3 HOUR 

Default Setting 

NO 

Delete All? 

NO 

The Search Feature will scan through your photos and automatically 

look for changes in regions that you identify in Setup. 

In search mode, the PlotStalker software scans through the .mlt photo file, stops 

on a photo when changes are found in your identified region, and then highlights 

the changes in blue. You can click anywhere in the video viewing area to remove 

the blue highlights.

Click the Settings button to activate

the Region and Sensitivity settings

for the Activity Search 

Click on the Set Motion Search Area Button.  

Use the mouse to select and drag the red outline around the area you want to 

search for movement.  This allows you to focus on a very precise area if 

required.

Click OK button on the Settings Popup window to confirm your settings and 

exit the menu.

Set to High, Medium or Low - This sets the level of pixel change the program 

will detect.  Note; a pixel change will occur with a color, intensity, lighting or 

movement so this setting is critical to obtain the desired results.  

Click on Default button to return to the default values for Search Area and 

Sensitivity settings

Provides the ability to search for 

changes in the photo in a specific 

region rather than the entire photo.