Mobility Electronics NP644 User Manual

NP644 IEEE 802.11g Wireless Network USB Adaptor 

37

YML787 Rev1 

ACA (Australian Communications Authority) requires you to be aware of the following information and 

warnings:
(1)   This unit shall be connected to the Telecommunication Network through a line cord which meets the 

requirements of the ACA TS008 Standard.

(2)   This equipment has been tested and found to comply with the Standards for C-Tick and or A-Tick 

as set by the ACA. These standards are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses, and can radiate radio noise 

and, if not installed and used in accordance with the instructions detailed within this manual, may 

cause interference to radio communications. However, there is no guarantee that interference will 

not occur with the installation of this product in your home or office. If this equipment does cause

some degree of interference to radio or television reception, which can be determined by turning the 

equipment off and on, we encourage the user to try to correct the interference by one or more of the 

following measures:

• 

Change the direction or relocate the receiving antenna.

• 

Increase the separation between this equipment and the receiver.

• 

Connect the equipment to an alternate power outlet on a different power circuit from 

that to which the receiver/TV is connected.

• 

Consult an experienced radio/TV technician for help.

(3)   The power supply that is provided with this unit is only intended for use with this product. Do not use 

this power supply with any other product or do not use any other power supply that is not approved 

for use with this product by NetComm. Failure to do so may cause damage to this product, fire or

result in personal injury.