MiTAC 9250T-LMB User Guide

3

The Power On/Off switch is located on the top 
of the Magellan RoadMate receiver.

1.  Press the power switch.
2.  After the initial splash screen the 

Warnings screen is displayed.  Read and 
tap 

 .  

1.  Press the power switch. The receiver will 

automatically power off in 15 seconds.
[Cancel] cancels the power off sequence 
and returns to last viewed screen.
[Power Down Now] turns the receiver 
off immediately, bypassing the 15 second 
delay.

Note:

  Anytime the power cable is 

disconnected from the receiver or if power is 
turned off at the 12v power receptacle, the 
receiver will begin the power off sequence.

The instructions shown here are for pairing a 
phone for normal use.  

1.  The first time you use Bluetooth in your 

Magellan RoadMate receiver, the receiver 
will automatically ask you if you want to 
pair a phone.

2.  After selecting Yes the receiver is in 

pairing mode.  Follow the instructions 
in your phone manual to set it in pairing 
mode.  

3.  After the phone has searched for new 

devices, select “Magellan Roadmate” from 
the list.

4.  Your phone will ask for a passcode.  
5.  Enter ‘1234’.Tap Yes on the Magellan 

RoadMate.

6.  A screen will confirm the successful 

pairing.

The Magellan RoadMate receiver has an 
internal battery that is charging whenever 
the receiver is connected to external power.  

Note:

  The battery can only be serviced by 

authorized Magellan repair facilities.

1.  While viewing the Map screen, tap on the 

Menu button in the right corner. 

2.  The battery level indicator is located in 

the upper right corner of the Main Menu, 
just below the satellite signal indicator.  
Green bars indicate battery level.

1.  Tap the speaker icon . Additional controls 

appear.

2.  Tap the speaker button to mute the 

volume, or tap the ‘+’ or ‘-’ buttons to raise 
or lower the volume.

3.  Tap 

 .