Microsoft ES4612 User Manual
Basic Configuration
3-15
3
CLI – Enter the following command.
Setting the Switch’s IP Address
This section describes how to configure an initial IP interface for management
access over the network. The IP address for this switch is obtained via DHCP by
default. To manually configure an address, you need to change the switch’s default
settings to values that are compatible with your network. You may also need to a
establish a default gateway between the switch and management stations that exist
on another network segment (if routing is not enabled on this switch).
access over the network. The IP address for this switch is obtained via DHCP by
default. To manually configure an address, you need to change the switch’s default
settings to values that are compatible with your network. You may also need to a
establish a default gateway between the switch and management stations that exist
on another network segment (if routing is not enabled on this switch).
You can manually configure a specific IP address, or direct the device to obtain an
address from a BOOTP or DHCP server. Valid IP addresses consist of four decimal
numbers, 0 to 255, separated by periods. Anything outside this format will not be
accepted by the CLI program.
address from a BOOTP or DHCP server. Valid IP addresses consist of four decimal
numbers, 0 to 255, separated by periods. Anything outside this format will not be
accepted by the CLI program.
Command Usage
• This section describes how to configure a single local interface for initial access to
• This section describes how to configure a single local interface for initial access to
the switch. To configure multiple IP interfaces on this switch, you must set up an
IP interface for each VLAN (page 3-197).
IP interface for each VLAN (page 3-197).
• To enable routing between the different interfaces on this switch, you must enable
IP routing (page 3-196).
• To enable routing between the interfaces defined on this switch and external
network interfaces, you must configure static routes (page 3-211) or use dynamic
routing; i.e., either RIP (page 3-213) or OSPF (page 3-223).
routing; i.e., either RIP (page 3-213) or OSPF (page 3-223).
• The precedence for configuring IP interfaces is the IP / General / Routing Interface
Console#show bridge-ext
Max support vlan numbers: 255
Max support vlan ID: 4094
Extended multicast filtering services: No
Static entry individual port: Yes
VLAN learning: IVL
Configurable PVID tagging: Yes
Local VLAN capable: Yes
Traffic classes: Enabled
Global GVRP status: Disabled
GMRP: Disabled
Console#
Max support vlan ID: 4094
Extended multicast filtering services: No
Static entry individual port: Yes
VLAN learning: IVL
Configurable PVID tagging: Yes
Local VLAN capable: Yes
Traffic classes: Enabled
Global GVRP status: Disabled
GMRP: Disabled
Console#