Microtek DLP CX6 User Manual
M
AINTENANCE AND
S
ECURITY
Replacing the Projection Lamp
The projection lamp should be replaced when it burns out. It should only be replaced with a certified
replacement part, which you can order from your local dealer.
replacement part, which you can order from your local dealer.
Important:
1. The lamp contains a certain amount of mercury and should be disposed of according to local or-
dinance regulations.
dinance regulations.
2. Avoid touching the glass surface of the new lamp: Doing so may shorten its operation life.
Warning:
1. Be sure to turn off and unplug the projector at least an hour before replacing the lamp. Failure to
do so could result in a severe burn.
do so could result in a severe burn.
2. It is recommended that you do not attempt to replace the lamp while the projector is installed on
a ceiling. If you do attempt this, wear protective goggles to prevent glass from a ruptured lamp ge t-
ting into your eyes.
a ceiling. If you do attempt this, wear protective goggles to prevent glass from a ruptured lamp ge t-
ting into your eyes.
1.
Lift the screw cover (A).
Remove the screw on
the lamp compartment
cover (B) and then lift
the lamp compartment
cover (C ).
Remove the screw on
the lamp compartment
cover (B) and then lift
the lamp compartment
cover (C ).
2.
Remove the two screws
from the lamp module
(A) and then lift the
module handle up (B).
from the lamp module
(A) and then lift the
module handle up (B).
3.
Pull up firmly to remove
the lamp module.
the lamp module.