Microboards Technology CD Disc-to-Disc Office Copier II User Manual
Orbit II Disc-to-Disc Copier Reference Manual – Revision I
13
5.4 Initial Orbit II Copying System Checks:
Turn Power On by operating the switch on the external Power Supply. The system’s power on
sequence will take a few seconds, but it should conclude with the display shown in the photograph
below. If the Copy CD-to-CD? prompt appears, your unit’s electronics are functioning properly.
Proceed with step 5.5 Navigating the Orbit II Menu Tree.
sequence will take a few seconds, but it should conclude with the display shown in the photograph
below. If the Copy CD-to-CD? prompt appears, your unit’s electronics are functioning properly.
Proceed with step 5.5 Navigating the Orbit II Menu Tree.
If you do not see anything on the display, check the external power supply connections. Make
sure the red light on the external power supply goes on when you turn on the power switch. If the
light does not go on, either the AC Receptacle you used does not have power, or the external
power supply may be defective. Contact Microboards Technology Technical Support.
sure the red light on the external power supply goes on when you turn on the power switch. If the
light does not go on, either the AC Receptacle you used does not have power, or the external
power supply may be defective. Contact Microboards Technology Technical Support.
If the display has any other message, or is unreadable, Contact Microboards Technology Technical
Support.
Support.
5.5 Navigating the Orbit II Menu Tree:
This is the top level of the Orbit II operating system menu tree.
1 Line x 16 Character
Display
2 Key
Keyboard
Orbit II Display and 2 Key Control Panel