Micron Technology Transport LT User Manual

Page of 170
FCC Notice
Appendix A - Regulatory
149
Appendix A - Regulatory
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions:(1) this device may not cause harmful interference, and 
(2) this device must accept any interference received, including interference that 
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B 
digital device pursuant to Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential 
installation. This equipment generates radio frequency energy and if not installed 
and used in accordance with the instructions, may cause harmful interference. If 
this equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following 
measures:
• 
Reorient or relocate the receiving antenna.
• 
Increase the separation between the equipment and receiver.
• 
Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.
• 
Consult the dealer or an experienced radio/TV technician for help.
If necessary, the user should consult the dealer or an experienced radio/television 
technician for additional suggestions. The user may find the following booklet 
helpful: "Something About Interference." This is available at FCC local regional 
offices. Our company is not responsible for any radio or television interference 
caused by unauthorized modifications of this equipment or the substitution or 
attachment of connecting cables and equipment other than those specified by our 
company. The correction will be the responsibility of the user. Use only shielded 
data cables with this system.
Federal Communications 
Commission (FCC) Part 68 
Statement
This equipment compiles with part of the FCC rules. On the back of this 
equipment is a label that contains, the FCC registration number and the ringer 
equivalence number (REN) for this equipment. If requested, this information must 
be provided to the telephone company.
This equipment uses the following USOC jacks: RJ11C