Mellerware TWEETY WB203103 0 W User Manual

Page of 4
Safety advice and cautions
-Read these instructions carefully before switching 
on the appliance and keep them for future consul-
tation.
-This appliance is only for domestic use, not 
industrial use.
-Do not leave the appliace connected and 
unattended when not in use.
Moreover, this will allow saving energy and 
extending the life of the appliance.
-Do not leave the appliance within the reach of 
children or disabled individuals.
-Before connecting the appliance to the mains, 
check that the voltage indicated on the nameplate 
coincides with the mains voltage.
-Do not use the appliance near the shower, bath or 
other containers holding water.
-Before picking up the appliance after falling into 
water disconnect it immediately.
-Do not use the appliance on wet hair,
-Do not use the appliance if the cable or plug are 
damaged, or if not functioning correctly.
-Keep the cable away from hot surfaces.
-Do not strecth, bend or warp the cable round the 
appliance.
-Do not throw or insert anything into any of the 
appliance's cavaties.
-Do not leave the appliance switched on top of any 
surface.
-Do not use the appliance where aerosols are in 
use.
-Do not position the hot parts of the appliance on 
heat-sensitive surfaces.
-The applaince heats when in operation. Do not 
bring the hot parts into contact with the skin to 
avoid burns.
-Never leave the appliance connected to the 
socket.
-Never put the appliance away when it is still hot or 
connected.
-No liablility is accepted for damage caused 
through inappropriate handling or use other than 
that stipulated in this manual.
-Never wrap the cable around the appliance when 
it is still hot.
Instructions for use
-Connect the appliance to a socket. This is a mul-
tivoltage appliance, it can therefore be used in any 
part of the world (from 110V to 230V).
-Operate the start/stop switch.
-Select the desired temperature using the tempera-
ture control (110°C min - 200°C max).
-The pilot light will come on indicating that the ap-
pliance is heating up.
The hair straightener has a built-in ceramic PTC 
system to keep the temperature of the ceramic 
plates constant.
-In order to straighten the hair perfectly, take a 
strand which is not too thick.
-Starting at the root, place it between the plates in a 
perpendicular position and gently pull downwards 
until reaching the ends of the strand. If necessary 
repeat this action various times.
-Apply the same technique to the rest of the hair.
-When finished, disconnect the appliance by put-
ting the switch in the stop position and unplug it 
from the socket.
Cleaning
-Disconnect the aplliance from the mains and leave 
to cool before proceeding to clean.
-Clean the appliance with a damp cloth and dry af-
terwards.
-Never submerge the appliance in water or any 
other liquid or put it under running water.
-Do not use solvents or abrasive products for 
cleaning.
Problems and Solutions
Should the mains connection fail, do not try to re-
place it since this is potentially dangerous. Take 
the appliance to an authorised Technical Support 
Service. The same applies to any other type of 
problem.
This appliance complies with the Low Voltage Di-
rective 73/23/EEC and with Electromagnetic Com-
patibility Directive 89/336 EEC.
WB20310_HAIRSTRAIGHTENER_IM.indd   3
WB20310_HAIRSTRAIGHTENER_IM.indd   3
6/3/2010   11:51:26 AM
6/3/2010   11:51:26 AM