MartinLogan VENT-FREE FIREPLACE SYSTEMS 33ISDG User Manual
22
23D8036
LOG PLACEMENT
Figure 19 - Installing
Right Base Log (#1)
Before you begin — This unit is supplied with six (6) ceramic fi ber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from ceramic fi bers. After handling the logs, wash your hands gently with
soap and water to remove any traces of fi bers.
Always wear gloves to prevent skin irritation from ceramic fi bers. After handling the logs, wash your hands gently with
soap and water to remove any traces of fi bers.
INSTALLING BLAZING OAK LOGS ON
BURNER
BURNER
W
ARNING
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and
other problems may result if the logs are not properly and fi rmly positioned in the appliance. Never
add additional logs or embellishments such as pine cones, vermiculite or rock wool to the heater.
Only use the logs and TPB-RW (rock wool) supplied with the unit.
other problems may result if the logs are not properly and fi rmly positioned in the appliance. Never
add additional logs or embellishments such as pine cones, vermiculite or rock wool to the heater.
Only use the logs and TPB-RW (rock wool) supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts specifi cally
approved for this heater may result in property damage or personal injury.
approved for this heater may result in property damage or personal injury.
Figure 20 - Installing
Rear Log (#2)
Pins
Right Base
Log (#1)
1. Place right base log (#1)
on two pins located on the
right side of the grate. See
Figure 19.
right side of the grate. See
Figure 19.
Rear Log (#2)
Right Base Log (#1)
2. Place rear log (#2) on
two pins on back of
grate allowing the right
end of the rear log to rest
on top of the right top
log.
grate allowing the right
end of the rear log to rest
on top of the right top
log.
See Figure 20.
Pins