Lucent Technologies Medical Alarms Release 3 Version 8 User Manual

8. Enter

 y

. The system automatically reboots and the remote console 

port comes up as a regular dial-in port with the 

login:

 prompt 

displayed.

As the system reboots, the shutting-down messages appears on the 
remote console. When the system starts to come back up, the 
system boot diagnostics should appear on the local console. After 
the system reboots, a login prompt should appear on the local 
console.

9. Log into the local console as 

root.

The console has been redirected from the remote console to the 
local console.

3

For information on setting up the alarm origination manager on the HA 
servers, see “CentreVu CMS R3V8 Alarm Origination Manager (585-215-
884). 

C

For information about setting up the NTS, see “Setting up the NTS”, in 
Chapter 2 of “CentreVu Call Management System R3V8 Software 
Installation and Setup” (585-210-941). 

3

This procedure is performed on NTS devices when:

the NTS is newly installed, or 

the NTS requires reconfiguration during a manual HA server switch-
over after the HA server to which the NTS was initially connected 
has experienced a failure event  

1. Connect a dumb terminal to the Console Port on the rear of the NTS 

using the console cable and adapter that came with the NTS. On 
the 8- and 16-port NTSs, the Console Port is port #1.

You will need the following for the 8- and 16-port units:

Console Cable

Adapter - comcode 407361823

Null Modem - comcode 407122043.