LSI MegaRAID(R) 6 Gb/s SAS RAID Controllers 25083 User Manual

 

This section provides detailed instructions for installing your MegaRAID 
6Gb/s SAS RAID controller. 

Step 1.

Unpack the MegaRAID 6Gb/s SAS RAID controller

Unpack and remove your RAID controller. Inspect it for 
damage. If it appears damaged, or if any of the following items 
are missing, contact your LSI support representative. The RAID 
controller is shipped with the following items:

–

A CD containing MegaRAID drivers for supported 
operating systems, an electronic version of this 
User’s Guide, and other related documentation

–

A license agreement

–

Warranty information

Step 2.

Turn off the Power to the System

Turn off the power to the computer, and disconnect the AC 
power cord. Remove the computer cover. Refer to the system 
documentation for instructions. Before you install the controller, 
make sure that the computer is disconnected from the power 
and from any networks.

Step 3.

Review the RAID Controller Jumpers and Connectors

The jumpers are set at the factory, and you usually do not need 
to change them. See 

 for diagrams of the MegaRAID 

6Gb/s SAS RAID controllers with their jumpers and connectors.

Step 4.

Install the RAID Controller

Select a PCI Express slot, and align the controller’s PCI 
Express bus connector to the slot. Press down gently, but firmly, 
to make sure that the card is seated correctly in the slot. Secure 
the bracket to the computer chassis with the bracket screw. 

 shows the installation of the MegaRAID SAS 

9260-8i RAID controller in a PCI Express slot.