Linear CCTV CAMERA RE-BWC1 Leaflet

Copyright © 2007 Linear Corporation 

227793 A

RE-BWC1

Linear’s Model RE-BWC1 (P/N ACP00886A) CCTV camera can be installed inside 
the RE-1 Entry System. The camera provides a video signal for viewing the area in 
front of the entry system
The camera is continuously powered by the RE-1. The camera’s infrared light emitters 
illuminate the area directly on front of the entry system for nighttime or low light 
operation.
The camera focus has been factory adjusted to a range of three to four feet.
The RE -1 CAMERA jack is used to connect the camera to the main circuit board with 
the single-ended modular cable supplied with the camera. This cable routes power to, 
and video from the camera.
The RE-1 VIDEO jack is for connection to a video cable with a Type “BNC” connector. Up 
to 300 feet of 75-ohm RG-59 video cable can be used. Longer cable runs may require the 
use of a video amplifi er.

This Linear product is warranted against defects in material and workmanship 
for twenty four (24) months. The Warranty Expiration Date is labeled on the 
product. This warranty extends only to wholesale customers who buy direct from 
Linear or through Linear’s normal distribution channels. Linear does not warrant 
this product to consumers. Consumers should inquire from their selling dealer 
as to the nature of the dealer’s warranty, if any. There are no obligations or 
liabilities on the part of Linear LLC for consequential damages arising 
out of or in connection with use or performance of this product or other 
indirect damages with respect to loss of property, revenue, or profi t,  or 
cost of removal, installation, or reinstallation. All implied warranties, including 
implied warranties for merchantability and implied warranties for fi tness, are valid 
only until Warranty Expiration Date as labeled on the product. This Linear LLC 
Warranty is in lieu of all other warranties express or implied.

All products returned for warranty service require a Return Product Authorization 
Number (RPA#). Contact Linear Technical Services at 1-800-421-1587 for an 
RPA# and other important details.

DISCONNECT THESE
TWO CONNECTORS

REMOVE THESE
4 SCREWS

REMOVE
CIRCUIT
BOARD

SECURE THE CAMERA ASSEMBLY
WITH TWO SCREWS

INSERT WIRING
HARNESS PLUG
INTO THE 2-PIN
LIGHTING
CONNECTOR 

PLUG THE CAMERA CABLE
INTO THE CAMERA'S JACK
AND THE RE-1'S CAMERA JACK

RE-1 

CAMERA

JACK

CAMERA
CABLE FROM
CAMERA'S JACK

CONNECT THE VIDEO CABLE FOR THE MONITOR
TO THE RE-1'S VIDEO OUTPUT CONNECTOR

RECONNECT THESE
TWO CONNECTORS

SECURE WITH
4 SCREWS

REPLACE
CIRCUIT
BOARD

INSTR,INSTL,RE-BWC1 - LINEAR P/N:

 227793 A - INK:

 BLA

CK - MA

TERIAL:

 20 LB

. MEAD BOND - SIZE:

 8.500”

 X 11.000”

 - SCALE:

 1-1