Lantronix Network Hardware 900-598 User Manual
6: Network Settings
PremierWave XC User Guide
37
To Configure Network 1 Interface Settings
Using Web Manager
To modify Ethernet (eth0) settings, click Network on the menu and select Network 1 ->
Interface -> Configuration.
Interface -> Configuration.
Using the CLI
To enter the eth0 command level: enable -> config -> if 1
Using XML
Include in your file: <configgroup name="interface" instance="eth0">
To View Network 1 Interface Status
Using Web Manager
On the Network Interface Status page, you can view both the current operational settings as well
as the settings that would take effect upon a device reboot.
as the settings that would take effect upon a device reboot.
To view the Ethernet (eth0) Status page, click Network on the menu and select Network 1 ->
Interface -> Status.
Interface -> Status.
Network 1 Link Settings
Physical link parameters can be configured for an Ethernet (eth0) Network Interface (see table
below).
below).
Table 6-4 Network 1 (eth0) Link Settings
Network 1 Ethernet (eth0)
Link Settings
Link Settings
Description
Speed
Select the Ethernet link speed. (Default is Auto)
Auto = Auto-negotiation of Link Speed
10 Mbps = Force 10 Mbps
100 Mbps = Force 100 Mbps
Duplex
Select t he Ethernet link duplex mode. (Default is Auto)
Auto = Auto-negotiation of Link Duplex
Half = Force Half Duplex
Full = Force Full Duplex
Notes:
When speed is Auto, duplex must be Auto or Half.
When speed is not Auto, duplex must be Half or Full.
Fixed speed Full duplex will produce errors connected to Auto, due to duplex mismatch.