Intermec 700 User Manual
Introduction
Chapter
—
1
22
700 Series Color Mobile Computer User’s Manual
Vibrator
Note: This information does not apply to the 730 Computer.
If your 700 Color Computer is built with an imager or scanner and the
vibrator is disabled, do the following instructions to enable the vibrator. If
you are not able to enable the vibrator, then contact Customer Support.
vibrator is disabled, do the following instructions to enable the vibrator. If
you are not able to enable the vibrator, then contact Customer Support.
For information about setting volume levels for screen taps, ActiveSync
alert noises, etc., tap Start
alert noises, etc., tap Start
>
Help > Pocket PC Basics
, then select
Notifications.
See Chapter 7, “Programming,” to see how to programmatically control the
vibrator. See Appendix A, “Configurable Settings,” for more information
about the Beeper Volume option.
vibrator. See Appendix A, “Configurable Settings,” for more information
about the Beeper Volume option.
Note: Each time the 700 Color Computer is cold-booted, all default set-
tings are restored.
tings are restored.
For Units With PSM Builds Older than 3.00
1
Tap Start > Settings > the System tab > Data Collection to access its
control panel applet.
control panel applet.
2
Use the right and left arrows to scroll to the Beeper/LED tab, then tap
this tab.
this tab.
3
Tap Beeper, select the “Vibrate” option, then tap Apply.
4
Tap ok to confirm this change, then tap ok to exit the Data Collection
control panel applet.
control panel applet.