Intermec F4 User Manual
Intermec EasyCoder F4 – Installation & Operation IPL Version, Ed. 3
18
Chapter 3
Starting Up
Switching On
Before switching on the printer, make the necessary connections
and check that the printhead is engaged.
and check that the printhead is engaged.
Switch on the power using the On/Off switch on the rear plate. The
“Power” control lamp on the front panel lights up when the power
is on. Wait for a few moments, while the printer loads the program
and runs some self-diagnostic tests.
“Power” control lamp on the front panel lights up when the power
is on. Wait for a few moments, while the printer loads the program
and runs some self-diagnostic tests.
While the printer is initialized, the progress of the initialization
is indicated by an increasing number of colons on the lower line
in the display:
is indicated by an increasing number of colons on the lower line
in the display:
Initializing
:::
:::
When the initialization is completed, a label is fed out. Then the
following message appears, indicating that the printer is ready
for operation:
following message appears, indicating that the printer is ready
for operation:
IPL Ver 1.3
9600-8-N-1-X/X
9600-8-N-1-X/X
The upper line indicates the IPL version number and lower line
shows the either the present serial communication setup or an
error message:
- Paused
- Printhead Up
- Press Feed
- Paper Out
- Ribbon Out
- Printhead Hot
shows the either the present serial communication setup or an
error message:
- Paused
- Printhead Up
- Press Feed
- Paper Out
- Ribbon Out
- Printhead Hot