ICOM IC-V85 Instruction Manual

44

10

PAGER/CODE SQUELCH

D

D

Your ID code 

be programmed into code channel C0.

Up to 6 transmit codes (codes that you transmit) are pro-
grammable into code channels, C1 to C6, if required.

q Push 

, then push 

(0) to enter 

OPTION SET

MODE

.

• Rotate 

to select “dtm.PG” or “dtm.CS,” if “dtm.OF” ap-

pears.

w Push and hold 

(0) for 1

sec. to enter the code selection
mode.

• One of either “CP” or “C0” to “C6”

blinks.

• “C0” is your ID code and “C1” to “C6” are transmit codes.

e Rotate 

(or push 

Y

Y

/

Z

Z

) to select code channel C0.

• Each transceiver should have a different ID code.

r Enter the desired 3-digit ID

code via the keypad.

t Rotate 

(or push

Y

Y

/

Z

Z

) to select a transmit

code channel from C1 to C6. 

y Enter the desired 3-digit transmit code via the keypad.

u Push 

, then push 

(6) to set the channel to “re-

ceive inhibit” or “receive accept.”

• When “receive inhibit” is set, “SKIP” appears as below.
• Code channel C0 cannot be set as “receive inhibit.”
• See the table for “receive accept” and “receive inhibit” details

(p. 43).

i Repeat steps t and y to set additional transmit code

channels, if desired.

o Push 

✱

(or 

) to exit code selection mode.

➥ “Receive accept” (“SKIP” indicator does not appear) ac-

cepts pager calls when the transceiver receives a signal
with a code the same as that in the code channel.

➥ “Receive inhibit” (“SKIP” indicator appears) ignores calls

even when the transceiver receives a code the same as
that in the code channel. Transmit codes should therefore
be programmed for “receive inhibit,” otherwise the trans-
ceiver will not reject unnecessary calls.

or