IBM Marine Radio DS4700 User Manual
Note: Perform this step if the attached storage expansion enclosures are
EXP710s or EXP100s only. The EXP810 storage expansion enclosure
IDs are automatically set by the controllers to be unique when they are
cabled together.
IDs are automatically set by the controllers to be unique when they are
cabled together.
12. Perform one of the following cabling tasks to enable management of the
DS4700 Express configuration:
v
If you are using out-of-band management, cable the DS4700 Express
Ethernet ports to either the management workstation or the host.
Ethernet ports to either the management workstation or the host.
v
If you are using in-band management, cable the DS4700 Express host
channels to the fibre channel host bus adapters (HBAs) in either the hosts
or the fibre channel switch that connects to the host HBAs. See “Connecting
hosts to the DS4700 Express” on page 104.
channels to the fibre channel host bus adapters (HBAs) in either the hosts
or the fibre channel switch that connects to the host HBAs. See “Connecting
hosts to the DS4700 Express” on page 104.
13. Connect the power cables for the DS4700 Express. See “Cabling the ac power
14. Power on the attached storage expansion enclosure and the DS4700 Express
Storage Subsystem using the procedure described in “Powering on the storage
subsystem” on page 119.
subsystem” on page 119.
15. Install the DS4000 Storage Manager host software on the management
workstation (for out-of-band management) or on the host (for in-band
management). Refer to the IBM System Storage DS4000 Storage Manager
Version 10 Installation and Host Support Guide for the appropriate operating
system for instructions on how to install the DS4000 Storage Manager host
software.
management). Refer to the IBM System Storage DS4000 Storage Manager
Version 10 Installation and Host Support Guide for the appropriate operating
system for instructions on how to install the DS4000 Storage Manager host
software.
16. Use the DS4000 Storage Manager host software to verify the configuration.
17. Review and perform the procedures described in “Performing the DS4000
Handling static-sensitive devices
Attention:
Static electricity can damage electronic devices and your system. To
avoid damage, keep static-sensitive devices in their static-protective packages until
you are ready to install them.
you are ready to install them.
To reduce the possibility of electrostatic discharge (ESD), observe the following
precautions:
precautions:
v
Limit your movement. Movement can cause static electricity to build up around
you.
you.
v
Handle the device carefully, holding it by its edges or its frame.
v
Do not touch solder joints, pins, or exposed printed circuitry.
v
Do not leave the device where others can handle and possibly damage the
device.
device.
v
While the device is still in its static-protective package, touch it to an unpainted
metal part of the system unit for at least two seconds. This drains static electricity
from the package and from your body.
metal part of the system unit for at least two seconds. This drains static electricity
from the package and from your body.
v
Remove the device from its package and install it directly into your system unit
without setting it down. If it is necessary to set the device down, place it in its
static-protective package. Do not place the device on your system unit cover or
on a metal table.
without setting it down. If it is necessary to set the device down, place it in its
static-protective package. Do not place the device on your system unit cover or
on a metal table.
v
Take additional care when handling devices during cold weather because heating
reduces indoor humidity and increases static electricity.
reduces indoor humidity and increases static electricity.
Chapter 2. Installing the storage subsystem
33