IBM Communications software 1000-90 User Manual
COMM.EXE
9
LI-3000A Portable Area Meter
The LI-3000A is configured as a DCE device. Most computers can
be connected to the LI-3000A using the 1000-04 printer cable and a
female-to-female gender changer. To send files from the LI-3000A
to a computer, use the following functions:
be connected to the LI-3000A using the 1000-04 printer cable and a
female-to-female gender changer. To send files from the LI-3000A
to a computer, use the following functions:
1.
Press the
MENU
key to access the functions needed to transfer
data. In the list of menu items are
SET I/O
and
PRINT FILES
.
2.
Set the I/O parameters as follows:
BAUD = 4800
DATA BITS = 8
STOP BITS = 2
PARITY = NONE
CHECK DTR = N (not used)
XON/XOFF = N (not used)
CHECK RTS = N (not used)
BAUD = 4800
DATA BITS = 8
STOP BITS = 2
PARITY = NONE
CHECK DTR = N (not used)
XON/XOFF = N (not used)
CHECK RTS = N (not used)
3.
Press
Enter
at the
PRINT FILES
function. Enter the range of
files to be transmitted out the RS-232C port.
LI-1600 Steady State Porometer
The LI-1600 is configured as a DTE device. To send data from the
LI-1600 to a computer, follow these steps:
LI-1600 to a computer, follow these steps:
1.
Your LI-1600 must support RS-232C communications (serial
numbers SSP-275 or above).
numbers SSP-275 or above).
2.
Connect the cable included with the LI-1600 (2230S) to the
9-pin port on the LI-1600 console. The 2230S plugs directly
into any DTE equipment.
9-pin port on the LI-1600 console. The 2230S plugs directly
into any DTE equipment.
3.
Data are transferred when the
HOLD
switch on the LI-1600
Sensor Head is toggled.