Hotbrick Dual WAN Firewall Router VPN 800/2 User Manual
HotBrick Network Solutions
9. Select
LAN & DHCP from the menu. You will see a screen like the example below.
Figure 2-3: LAN & DHCP
10. Ensure these settings are suitable for your LAN:
• The default settings are suitable for many situations.
• See the following table for details of each setting.
• See the following table for details of each setting.
11. Save your data, then go to Step 2, Installing the VPN 800/2 Firewall Router in your LAN.
Settings – LAN & DHCP
LAN IP
Configuration
Configuration
IP address - for the VPN 800/2 Firewall Router, as seen from the local LAN.
Use the default value unless the address is already in use or your LAN is
using a different IP address range. In the latter case, enter an unused IP
Address from within the range used by your LAN.
Use the default value unless the address is already in use or your LAN is
using a different IP address range. In the latter case, enter an unused IP
Address from within the range used by your LAN.
Subnet Mask -The default value 255.255.255.0 is standard for small (class
"C") networks. For other networks, use the Subnet Mask for the LAN
segment to which the VPN 800/2 Firewall Router is attached (the same value
as the PCs on that LAN segment).
"C") networks. For other networks, use the Subnet Mask for the LAN
segment to which the VPN 800/2 Firewall Router is attached (the same value
as the PCs on that LAN segment).
Page 10