Husqvarna Grinder SG13B User Manual

LUBRICATION

HUSQVARNA

-45

Lubricate using a grease gun until the grease 

squeezes out one nipple.
Use good quality MP grease. Grease from well-known 

brand names (petrochemical companies, etc.) usually 

maintains a good quality.

Peel back the rubber covers at both of the cable 

mountings. Grease both ends of the throttle cable 

and move the controls to end stop positions when 

lubricating. Refit the rubber covers on the cable after 

lubrication. Cables with sheaths will bind if they are 

not lubricated regularly. Binding in a cable may cause 

malfunction.
If the cable binds, remove the cable and hang it 

vertically. Lubricate it with thin engine oil until the oil 

begins to escape from the bottom.
Tip: Fill a small plastic bag with oil and tape it so that 

it seals against the casing and allow the cable to hang 

vertically from the bag overnight. If you do not succeed 

in lubricating the cable, it must be replaced.

8011-231

8011-234

Checking Engine Oil Level
Make sure that the machine is parked on flat ground 

with the engine stopped when checking the oil level.

Unscrew the dipstick and wipe it using paper towel 

1. 

or a lint-free rag.
Replace the dipstick without screwing it in. 

2. 

Remove and check the level on the dipstick.
Fill oil as necessary to the lip of the dipstick hole. 

3. 

Oil type, see above.
Check that the rubber gasket is in position and 

4. 

screw the dipstick back into place. DO NOT 

tighten it askew or too hard or you may damage 

the threads.

8011-020