HP Performance Optimized Data Center (POD) 240a User Manual
Component identification 9
Item
Component
Description
1
Canopy
The canopy has two 6.10 m (20 ft) parts that are installed on top of the HP
POD 240e NA.
2
Adiabatic units and
cradles
Each of the four cradles contain three Adiabatic units.
3
AHU service area end
walls
walls
The HP POD 240e offers AHU service access in these two locations.
4
IT section A (primary
structure)
structure)
The IT section A (primary structure) contains the ECS. Conditioned air passes
through the IT section A and IT section B structures to force cool air through the
through the IT section A and IT section B structures to force cool air through the
IT equipment.
5
Hot aisle
The hot aisle structure is a separate space where hot exhaust air from the
servers can be expelled out of the structure or recirculated. The HP POD 240e
isolates the IT sections from the hot aisle for efficiency.
isolates the IT sections from the hot aisle for efficiency.
6
IT section B (secondary
structure)
The IT section B (secondary structure) is similar to the IT section A (primary
structure), but IT section B does not contain the ECS.
IMPORTANT:
You must consult with the AHJ to determine the egress requirements for the hot-aisle
service area that you must provide. Requirements might include landings and stairs to be installed
at both ends of the hot aisle service area for emergency egress.
Parts and part number identification
Review all of the contents to identify the following for each component:
Regulatory model number
The following figure shows the location of the regulatory model number and the POD solution serial numbers
Regulatory model number
The following figure shows the location of the regulatory model number and the POD solution serial numbers
on the inside of each IT section, adjacent to the bump out.
Interior side view shown
Interior side view shown
CSC Safety Approval placard