Hotpoint HCM60 User Manual
AMC-3
2. Fix the 4 brackets A to the 4 corners of the cabinet opening, using the appropriate screws (Fig. 3).
The horizontal movement of the nut allows any width tolerance of the cabinet to be offset.
3. Fix the 2 angular brackets B to the machine (Fig. 3). The 2 vertical holes on the brackets allow the height of the machine
to be levelled and aligned.
4. Connect the machine to the electricity supply, observing the current safety regulations.
Important : The current plug must be reachable after the installation of the machine.
5. Place the machine in the centre of the cabinet, taking care that the horizontal side of the 2 angular brackets B are slotted
into the appropriate holes on the brackets A (Fig. 3).
6. Open the machine by lifting the handle and pulling outwards, taking care not to pull it out of the cabinet (Fig. 4).
7. Secure the machine using the appropriate screws C (Fig. 4).
8. Close the machine.
7. Secure the machine using the appropriate screws C (Fig. 4).
8. Close the machine.
The manufacturer declines any responsibility for persons or property and for the incorrect operation of the machine
if the above instructions are not observed in full.
if the above instructions are not observed in full.
Fig. 3
INSTALLATION OF THE MACHINE
ON/O
FF
ON/OFF
B
B
A
A
B