Hoya 15086 User Manual
59
B
asi
c Op
c Op
er
ati
o
o
n
s
3
1
Press the four-way controller (3) in Step 2 on p.58.
2
Turn the e-dial.
The flash compensation value is
displayed.
Press the d/i button to reset the value
to 0.0. (Available only when [Green
Button] is assigned to the d/i button in
[Green Button] of the [A Rec. Mode 3]
menu (p.144).)
displayed.
Press the d/i button to reset the value
to 0.0. (Available only when [Green
Button] is assigned to the d/i button in
[Green Button] of the [A Rec. Mode 3]
menu (p.144).)
1
Select a flash mode.
2
Slide the flash pop-up switch in
the direction of the arrow.
the direction of the arrow.
The built-in flash pops up.
3
Press the shutter release button halfway.
The flash starts charging.
4
Press the shutter release button fully.
The picture is taken.
• When the flash output exceeds its maximum amount, the compensation will
not be effective even if the compensation value is set to the plus (+) side.
• Compensating to the minus (-) side may have no effect if the subject is too
close, the aperture is set to a large opening, or sensitivity is high.
• The flash output compensation is also effective for external flash units which
support P-TTL auto flash mode.
Shooting with the Flash
Auto Flash Discharge
Auto Flash Discharge
+0.7
+0.7
Cancel
Cancel
OK
OK
OK
MENU