Honeywell Galaxy 3-48C Installation Instruction

The MAX

3

 is a proximity reader access control device for a single door, which can also be used for setting

and unsetting of your alarm control panel. The MAX

3

 can be configured in one of two ways:

Standalone

In this configuration the MAX

3

 can be used for either door control or alarm system set/unset control, by either

connecting the internal relay output to a door lock, external relay or into the keyswitch zone of the alarm
system. When in standalone mode the MAX

3

 is programmed and operated using the MAX

3

 proximity cards

or tags.The proximity cards and tags each have unique ID numbers and must be identified to the MAX

3

before being used to operate the system. The MAX

3 

 memory can store up to 999 ID numbers, including at

least three reserved for Masters. Once programmed, the ID number of the tags and cards  are stored indefi-
nitely in the MAX

3 

 memory until voided (removed) or erased. Removing power from the MAX

3 

 does not

erase the programming memory.
Note : The MAX

3

  defaults to standalone mode. It can be configured to on-line mode directly from and of the

Galaxy 3 Series control panels.

On-line

The MAX

3

 can operate in on-line mode, with the Galaxy 3 Series control panel range, as a completely inte-

grated module on the system. In this configuration the MAX

3

 can be used for both door control and alarm

system set/unset control with complete user traceability stored within the Galaxy control panel.
For detailed instructions on how to programme the MAX

3

 onto the system in on-line mode refer to Galaxy 3

Series Programming Manual IP1-0033, Option 63.2=MAX.

Your Max

3

 pack contains the following:

• Max

3

 proximity reader *

• Max

3

 drilling template

• Max

3

 installation instructions

• Surge suppressor
* The MAX

3

 is supplied with 3 metres of 12

wire E111235 AWG cable which is fixed and
sealed through a keyhole opening on the rear
surface of the MAX

3

 .

To mount the MAX

3

 use the step by step

diagrams provided with the drilling template.
The drilling template should be used as an aid
to locate the holes required to secure the
MAX

3

 and insert the connection cable.

The MAX

3

 comes with an infra red lid tamper.

The tamper is activated when the lid is re-
moved from the MAX

3

 unit.