Honeywell Galaxy 3-48C Installation Instruction
Galaxy 3 Series Installation Manual
A-2
Mounting the MAX
Attach the wired-up 10-way connector block to the pins on the rear of the MAX reader.
Surface Mounting the MAX
1.
If the wiring is not wall recessed, remove the appropriate knock-out (from the sides, top or bottom
of the MAX).
of the MAX).
2.
Using the MAX reader as a template locate the two mounting screws in the required positions.
NOTE: The MAX is positioned with the 2 LEDs at the top of the module.
3.
Securely attach the module to the wall with 2 No.8 roundhead 2 inch screws.
Flush Mounting the MAX
1.
Using the template on the lid of the MAX flush mounting kit box (P/N MX02), locate the position
of the screws and mark and cut-out the recess area required.
of the screws and mark and cut-out the recess area required.
NOTE: Ensure that there is sufficient wall surface to securely fix the screws.
2.
Fit the MAX reader into the flush mounting kit; push the reader in from the rear ensuring that the
four retaining arms on the flush mounting kit click into place
four retaining arms on the flush mounting kit click into place
3.
Securely attach the module to the wall with 2 No.8 roundhead 1½ inch screws.
NOTE: The MAX is positioned with the 2 LEDs at the top of the module.
Remove the backing from the facia label, line up the label images with the 6 LEDs and place it on the
face of the MAX.
face of the MAX.
Figure A-2 MAX LED’s
Installation Instructions (cont’d)
)
LED 4 (red)
void mode
void mode
LED 5 (red)
Nightlock mode
Nightlock mode
LED 6 (red)
programming mode
programming mode
LED 2 (red)
door closed
door closed
LED 3 (red)
add mode
add mode
LED 1 (green)
door strike open
door strike open
MAX