Honeywell Galaxy 3-48C Installation Instruction
Galaxy 3 Series Installation Manual
A-6
Operating Instructions (On-Line Modes)
The MAX must be presented with a valid user card to allow access. Opening the door while LED 2 is
on activates an alarm; the buzzer sounds and LED 1 flashes until the door is closed.
Activating the egress switch allows the door to be opened without activating an alarm when no card
has been presented to the MAX.
on activates an alarm; the buzzer sounds and LED 1 flashes until the door is closed.
Activating the egress switch allows the door to be opened without activating an alarm when no card
has been presented to the MAX.
Gaining Access
1.
Ensure that LED 2 is on and all other LEDs are off.
2.
Swipe the MAX with a standard user or nightlock access user card. LED 2 switches off and LED 1
switches on for the programmed Open Timeout.
switches on for the programmed Open Timeout.
3.
Open the door while the LED 1 is on and access the area.
4.
Close the door; LED 1 switches off and LED 2 switches on. The door must be closed within the
programmed Close Timeout; if the door remains open longer than this, an alarm is activated.
programmed Close Timeout; if the door remains open longer than this, an alarm is activated.
Nightlock Access (Stand-Alone Only)
Only cards programmed as nightlock access users can gain access when the MAX is nightlocked. The
operation is identical to the standard user card.
operation is identical to the standard user card.
NOTE: Access cannot be gained using a standard user card.
Card-Held Function
The MAX card can be assigned a single menu option (refer to option 42.2.8 = CODES.User
Codes.MAX Function). To activate the function assigned to the MAX card, hold the card in front of
the reader for three seconds; all of the LEDs switch on. If a keypad has been assigned to the MAX
function then it displays the details of this option. If no keypad is assigned, pressing a key on any of
the keypads assigned to a common group to the user displays the card-held function.
Codes.MAX Function). To activate the function assigned to the MAX card, hold the card in front of
the reader for three seconds; all of the LEDs switch on. If a keypad has been assigned to the MAX
function then it displays the details of this option. If no keypad is assigned, pressing a key on any of
the keypads assigned to a common group to the user displays the card-held function.
Card-Held System Setting
If the MAX card is assigned one of the setting options (option 12, 13, 14 & 16 – 19), the card-held
functions starts the setting procedure for the groups assigned to the card.
functions starts the setting procedure for the groups assigned to the card.
NOTE: If Group Restriction is assigned, then only the groups that are common to both the MAX
reader and the MAX user are set.
If all of the groups that are assigned to the MAX are set (either by the card-held function or by any
other setting means) all of the LEDs switch off.
To unset the system using the MAX, swipe the reader with a valid MAX card. The MAX reader beeps
and LED 2 switches on. All of the groups assigned to the MAX are instantly unset.
other setting means) all of the LEDs switch off.
To unset the system using the MAX, swipe the reader with a valid MAX card. The MAX reader beeps
and LED 2 switches on. All of the groups assigned to the MAX are instantly unset.
Operating Instructions