Hobart HR5 User Manual

– 7 –

Immediately after unpacking the oven, check for possible shipping damage. If oven is found to be
damaged after unpacking, save the packaging material and contact the carrier within 15 days of
delivery.

Prior to installation, test the electrical service to assure that it agrees with the specifications on the
machine data plate located on the right side panel near the controls.

The oven may be placed where cooking may be observed to enhance customer awareness, but  must
be installed on a level surface if the oven or warmer is not on casters.

The installation location must allow adequate clearances for servicing and for proper operation of the
front and rear doors.

• A minimum wall clearance of 10" (254 mm) from any glass, and 4" (101.6 mm) from each side panel

must be maintained.

Each oven and warmer is furnished on 1

9

⁄

16

" (39.7 mm) legs. Casters are included with the stacking kit.

The drip plate and rotor come in a separate boxed  kit with either a nonstick coated surface or stainless
steel surface. They must be assembled at installation.

Place the two bottom drip plates in oven. The two plates slant to the middle to allow fat to drip into the
grease drawer (Fig.1).

PL-41161