Heath Zenith SL-5411 User Manual

2

595-5766-03

For easy installation, select an existing light with a wall
switch for replacement.

❒

❒

Remove the existing light fixture.

❒

Install the mounting strap as shown using two screws
that fit your junction box.

❒

The plastic hanger can be used to hold the fixture
while wiring. The small end of the plastic hanger can
be threaded through the hole in the center of the
cover plate. The small end then goes into one of the
slots on the mounting strap.

❒

Route the Light Control’s wires through the large
gasket holes.

❒

Twist the junction box wires and fixture wires together
as shown. Secure with wire connectors.

❒

Align the Light Control cover plate and cover plate
gasket. Secure with the mounting bolt.

❒

Push the Rubber Plug firmly into place.

❒

If a wet location junction box was not used, caulk
the wall plate mounting surface with silicone
weather sealant.

White to
White

Lock Nut

To avoid water damage and
electrical shock, keep lamp
holders 30

°

 below horizontal.

Black to
Black

Gasket

For eave mount only:

❒

Swing the sensor head towards the clamp screw
joint.

If the sensor pops out of the ball joint, loosen the clamp
screw and push the sensor back into the ball joint.
Tighten the clamp screw when done.

❒

Then rotate the sensor head clockwise 180

°

 so the

controls face down.

Controls

For under eave installation, the sensor head must
be rotated as shown in the next two steps for proper
operation and to avoid the risk of electrical shock.

1234567890123456789

1234567890123456789

1234567890123456789

Mounting

Strap

Mounting

Bolt

Controls

Controls

Clamp Screw

❒

Adjust the lamp holders by loosening the lock nuts
but do not rotate the lamp holders more than 180

°

from the factory setting. When screwing in the
floodlamps, do not overtighten.

Keep lamps at least
1" (2.5 cm) from the
sensor. Do not al-
low the lamps to
block the lens.

Lens

Rubber

Plug