Gigabyte 7014 User Manual
Rev. 051208
page 80 of 152
Configuration – Save or Reset
The Configuration section of the web management gives an administrator the ability to save a running
configuration into the NVRAM. This step is needed in order for the switch to remember any changes after a
power cycle.
The Reset Configuration button will reload N-Tron’s factory default configuration settings. Doing so will
re-configure the 7000 Series switch to factory defaults.
In many cases it is desirable to restore factory defaults but retain the IP, Slot Configuration, Subnet Mask,
and Gateway Address settings. A choice is provided to this end.
configuration into the NVRAM. This step is needed in order for the switch to remember any changes after a
power cycle.
The Reset Configuration button will reload N-Tron’s factory default configuration settings. Doing so will
re-configure the 7000 Series switch to factory defaults.
In many cases it is desirable to restore factory defaults but retain the IP, Slot Configuration, Subnet Mask,
and Gateway Address settings. A choice is provided to this end.