GE RH30 LED System Installation Guide

• For retrofit, place LED driver in the location where the ballast was formerly located. 

• Make output (DC) connections as noted below:

• Make input (AC) connections using one of the two options below:

• The LED Driver is required to be reliably bonded to the protective ground conductor.

• To enable dimming operation and/or occupancy sensors you must connect leads from occupancy sensor or control system  

  (normally open contact) to the purple and gray leads of the power supply and adjust dimming switch as shown below.
Note: connection of occupancy sensor to the dimming leads will reduce light output to 20% normal output.
• Make output (contact closure) connections as noted below:

Connect the LED Driver output leads to the LED 

Light leads using the appropriate mating connector 

(Tyco p/n 794896-1). Terminals installed should be 

crimped using approved tooling and process per 

Molex specifications. Ensure that the connector 

cavities are correctly populated per the wire colors 

shown on page 3.

Ground driver to metal portion of the door frame. 

Connect the original Line and neutral wires (or 

Line 1 and Line 2 wires for 240 nominal VAC) to the 

2-way connector for the LED Driver input wires 

using the appropriate mating connector (JST p/n 

VLR-02V). Ensure that the connector cavities are 

correctly populated per the wire colors on page 3.

Ground driver to metal portion of the door frame. 

Remove the 2-way connector from the LED Driver 

by cutting the wires near the connector and strip 

the input wires. Using the appropriate wiring 

diagram on page 3, connect the original Line and 

neutral wires (or Line 1 and Line 2 wires for 240 

nominal VAC) to the LED Driver leads using twist 

lock wire connectors or other connection method 

approved for low temperature usage and stranded 

cable. 

Remove the 2-way connector from the LED Driver 

by cutting the wires near the connector and strip 

the output leads. Using the appropriate wiring 

diagram on page 3, connect the LED Driver output 

leads to the LED Light leads using wire connectors 

or other connection method approved for low 

temperature usage and stranded cable.
For non-dimming applications, cap the unused 

wires with 5/32” (4mm) twist on wire connectors. 
For Retrofit: Bundle and safely secure any unused 

wires by way of approved wire ties and wire 

connectors.

Connect the LED Driver dimming output leads to 

the occupancy sensor or control system using wire 

connectors or other connection method approved 

for low temperature usage and stranded cable.

•  The GEPS6000NCCON-SY LED Driver is capable of 

step dimming from 100% power to 20% power 

when used with a normally open contact closure 

occupancy sensor system. 

•  When using the GEPS6000NCCON-SY for dimming  

applications, the dimming switch setting must be 

switched to the left to enable the dimming feature. 

The following is the only recommended usage of 

occupancy sensors with the  

 

Immersion LED lighting system. Other methods, such 

as using occupancy sensors to switch the LED driver 

on and off is not recommended and will void the 

product warranty.