Extron electronic Extron Electronics Music Mixer DMP 44 LC User Manual

Install blank panels or other units on the rack shelf.

Furniture mount the DMP 44 LC using the optional mounting kit (Extron MBU 123, part 
number 70-212-01, as follows:

Attach the selected mounting brackets with the machine screws provided.

If feet were previously installed on the bottom of the cabinet, remove them.

Hold the unit with the attached brackets against the underside of the table or other 
furniture, or against the wall.  Mark the location of the screw holes of the bracket on 
the mounting surface.

Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch (6.4 mm) deep in the mounting 
surface at the marked screw locations.

Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting 
surface until just less than 1/4 inch of the head of the screw protrudes.

Align the mounting screws with the slots in the brackets and place the unit against 
the surface, with the screws through the bracket slots.

Slide the unit slightly forward or back, then tighten all four screws to secure it in 
place.