Generac Power Systems Lawn Mower K4080 User Manual
ATTACHING TO THE EXCAVATOR
•
Be sure to inspect all safety devices (including safety shields, guards, deflectors,
etc.) before each use.
etc.) before each use.
Safety Device
Examples
Shaft protection cap
Motor & gearbox
cover
Debris chain
curtain guarding
•
Maintain all safety decals and make sure they are visible to the operator and by-
standers. If decals are worn, contact your nearest Kubota dealer for replacements.
standers. If decals are worn, contact your nearest Kubota dealer for replacements.
•
Replace bent or broken blades with new ones. Do not attempt to weld or bend
damaged blades. This can cause cracking or other types of damage that could re-
sult in the blade being thrown from the brush mower.
damaged blades. This can cause cracking or other types of damage that could re-
sult in the blade being thrown from the brush mower.
•
Wear gloves and eye protection and exercise care when handling blades. Also be
alert to worn or damaged surfaces that could have sharp edges.
alert to worn or damaged surfaces that could have sharp edges.
•
Disengage hydraulics and shut off engine, bleed off hydraulic pressure to both high
and low flow circuits allowing all movement to stop before leaving the operator’s po-
sition to adjust, lubricate, clean, unclog, remove or install the attachment. See Ku-
bota KX080-3 Operators Manual for detailed instructions on bleeding off hydraulic
pressures.
and low flow circuits allowing all movement to stop before leaving the operator’s po-
sition to adjust, lubricate, clean, unclog, remove or install the attachment. See Ku-
bota KX080-3 Operators Manual for detailed instructions on bleeding off hydraulic
pressures.
•
Before working on or underneath the attachment, place blocks on both sides (front
and back) of operating vehicle tires or treads and under each end of the attachment
to prevent accidental lowering of the machine. Also remove the ignition key from
the operating vehicle and allow all movement to stop before beginning work.
and back) of operating vehicle tires or treads and under each end of the attachment
to prevent accidental lowering of the machine. Also remove the ignition key from
the operating vehicle and allow all movement to stop before beginning work.
ATTACHING TO THE EXCAVATOR 4
1
2
3