Gateway DVD Player User Manual
18
Chapter 2: Setting Up Your Player
www.gateway.com
3
If the player’s network card is a wired Ethernet card, connect one end of
an Ethernet cable to the network card, then connect the other end to an
Ethernet jack on your existing network.
an Ethernet cable to the network card, then connect the other end to an
Ethernet jack on your existing network.
4
After you connect video and audio cables and install the network card,
configure your video by following the instructions in
configure your video by following the instructions in
Installing batteries into the remote control
To install the batteries:
1
Turn the remote control over, then remove the battery cover.
2
Insert two AAA batteries into the battery bay. Make sure that the batteries
are oriented according to the diagram inside the battery bay.
are oriented according to the diagram inside the battery bay.
3
Replace the battery cover.
Important
Do not remove the card while the player is turned on. If
you remove the card while the player is on, all playback
of networked media will stop.
you remove the card while the player is on, all playback
of networked media will stop.