Ericsson IP Vision Dialog 4425 User Manual

BusinessPhone – Ericsson Dialog 4425 IP Vision

Start the Phone – Log On/Off

All system settings for your IP phone must be set by the system

administrator before you can use the phone.

Connect the required cables.

See section “

Note: Depending on the settings in your network and

telephone system, the start up procedure may be different

from phone to phone. Check the display on your phone and

read the required sections in this chapter to continue with

the start up procedure.

When this is done, and the phone is connected to the local network

(LAN), your phone starts the start-up procedure automatically

when connected to the mains.

Notes:

The phone does not work during a power failure. After a

power failure the phone will restart automatically. However,

when a password is requested, you must log on before the

phone can be used again.

Reset the phone

If your phone does not work properly, you can use the following

procedure to reset the phone. This procedure will also clear the

Call list. After the procedure you must log on again to use the

phone.

í É #

Press simultaneously for at least one second to reset the

phone.