Epson EQUITY II+ User Manual

There are three ways to reset. Because each is more powerful than the

last, try them in the order listed here:

If you are using MS-DOS, hold down 

and 

and press the 

key on the numeric keypad at the right of the keyboard. The screen goes

blank for a moment and then MS-DOS reloads. (MS-DOS must either

be on the diskette or be autobootable from the hard disk.) If this does
not correct the problem, try the second method.

Press the RESET button on the front panel. This method works even
when the keyboard does not respond to your commands. If this does not
correct the problem, try the third method.

Remove any diskettes from the floppy disk drives. Turn off the monitor

and any peripheral devices and then turn off the Equity II+ using the

power switch on the front panel of the main unit. Wait five seconds and
then switch the power back on.

Before you turn off your computer, save your data, exit the program you

are using, and then remove all diskettes from the disk drives. Turn off your
monitor and peripherals first, then turn off the main unit using the switch on
the front panel.