Epson BrightLink Solo Interactive Module (IU-01) Quick Setup Guide
11
English
Confirming the Projector Position
Once you have determined where to install the interactive module, you can determine whether the
projector’s position needs to be adjusted to avoid possible interference.
projector’s position needs to be adjusted to avoid possible interference.
You can mount the interactive module and then test the installation with your projector turned on. Or, you
can follow the steps below to calculate whether your projector’s position needs to be adjusted.
can follow the steps below to calculate whether your projector’s position needs to be adjusted.
1
Measure the following projector distances:
•
The distance from top of the projection area to the top edge of the projector’s lens (
a
)
•
The distance from the wall to the top of the projector’s lens (
c
)
2
Make sure the distance from the top of the projector lens to the top of the image (
a
) is less than:
(
b
–5.9 inches) ×
c
/41.73 inches
or (
b
–150 mm) ×
c
/1060 mm
If the distance from the top of the projector lens to the top of the image (
a
) is less than the calculated
value, the interactive module can be used without adjusting the projector position.
AVOID
Projector
Arm length is 41.73 inches (1060 mm)